Review of the RFP - puncher Bison 650EK from DIY

idea to buy punch came when I bought an apartment.She was with the secondary housing market and, as stated in the declaration, without repair.In this I was convinced with their own eyes, and immediately realized chtopereezd should be postponed until "better times".So, when I bring it in order.

It is clear that a new person alters any room "for themselves."So I wondered how long I would have to drill the drill, the chisel punch.Walls - concrete, with them as with a brick, can not cope.Asking for a while at a friend does not make sense, since my wife and our plans for remaking apartments here to work and work.Including the walls.In addition, they decided to change all the pipes, and lay them somewhat differently.

After work, went to the store, and eyes are dazzled.What to buy?I acted wisely, and all advise.He returned home and looked on the Internet.I wondered what should be a punch for home, and that's what I found out.

What to look for when choosing a punch

1. About patron, I realized one thing - you need to take home modification SDS +.As such, you can insert and drill, and the usual drill.
2. Hammers are light and heavy.Therefore, we must pay attention to weight.By the way, with this type of cartridge lighter tool.
3. Home is sufficient if the punch power will be in the range of 500 watts.
4. Modes.Most preferred is tri-mode or two-tool.The fact is that during operation can be caught "difficult" section.It makes no sense to take the single-mode model, because it is often necessary to drill, then work with a punch.For example, a drill (or drill) boils down to the river pebbles, which is added into the concrete mix.The tip of the drill will only slide on it and in depth will not work.Two or three mode - is when and drills, and hammer, and drill at the same time "swotting".
5. regards safety.If the drill is "clamped" to the wall, then drill and can snatch from the hands.At the gun they do not.Therefore, the injury did not get it, and the bit is not broken.By myself I know how they "fly", these drills.
6. And most importantly - decide what still need a tool.For models "for all occasions" does not happen.

reviewing many websites, I came to the conclusion that the domestic drills in characteristics no worse than imports (about China not a word).It turns out that often we pay for the logo, not a thing.So the next day bought the product "Bison CP-650EK" inexpensive, for 2648 rubles.

The characteristics of this quite "home" model.Stored in a neat case.Power 650 W at 1000 rev / min.The ability to drill concrete drills up to 24 mm, and more and is not necessary.3 modes of operation, ie complete "kit".There is depth stop opening passage, safety clutch.And that is good, light weight, so it is easy to operate.Yes, and the chuck.

I worked quite intensively this punch.Practice has shown that it is equally well drills and concrete, and brick.

disadvantage, in my opinion, in the "modest" configuration.But if you think about it, and the price is low.And still no reverse, so as you do not use a power screwdriver.However, it works reliably, no complaints.I even grooves Grooves under the wire.Although difficult places do not always take, power is not enough.But still, a drill, and this will not do.