Insulation penoplex - the technical characteristics and properties of the material

penoplex Insulation is used for thermal insulation of the various elements of buildings and structures, eg for insulation of foundations, floors, roofs.It is used for insulation components of utilities (water pipes, sewerage), the construction of storage tanks and even wells.Penoplex Plates come in different brands, which determines their use.

Basic properties penoplex material:

• not prone to burning;
• increased elasticity in compression;
• low thermal conductivity;
• does not absorb moisture:
• ease of installation;
• environmental friendliness;
• long service life;
• low weight;
• does not rot, is not destroyed by rodents, bugs and so on.;
• good resistance to aggressive substances.

Mark Penoplex "31C" is used for structures that are not subject to the dynamic or static load.Therefore, these plates are used to isolate the water supply system, heating networks, tanks and so on. D.

plates "35" brand have increased resistance to combustion.They are often used for interior decoration works (foundations, walls, floor).Penoplex this brand well it minimizes heat loss and is an excellent thermal insulator.

Penoplex mark "45" is capable of withstanding pressures up to 0.5 MPa.It is his property is used in the construction of airfields.It is used in road construction and the laying w / e ways.With the construction of buildings and structures it is used to isolate the buried foundations and floors that are subjected to high loads (eg industrial areas).

Here are some of the characteristics of this material.However, it should be borne in mind that each has its own particular brand Penoplex characteristic.Therefore, it is indicated only the general "range" for all brands.

Specifications Penoplex

1. material density (kg / m³) of 28 to 45
2. coefficient of thermal conductivity (W / (m · ° K) 0, 030 at 250 C
3. category fire from T1 to T4
4. vapor permeability coefficient of 0.007 - 0.008 (mg / m · h · Pa)
5. compressive strength at 10% deformation 0.2 - 0.5 MPa (kgf / cm²; t / m²)
6. standard sizes: 600 width (mm)
7. length 1200 - 2400 (mm)
8. thickness of 30 - 100 (mm)
9. 7) temperature range -50 ... + 75 (° C)

When using this material should be considered by the manufacturer recommendations temperature range,use of adhesives, as well as order placement during installation.See also the table of calculation Penoplex insulation thickness in different situations: