Driving laying laminate diagonally - where to start and what to provide

Before we deal with the laying of laminate diagonally, must understand in what cases it is expedient to do so.This scheme - not a simple one, and self-stacking material is some complexity.Especially, if there is not enough experience.

Firstly, if you do not want to mount the nut at the exit of the room.

Secondly, in the case of floor finishes in a room with a complex geometry with missing right angles, and the like.

All other advantages - for example, a stylish look, originality - at the discretion of the property owner.

feature diagonal laying laminate

procedure of preparatory activities the author deliberately skips.Who would want to clarify some points, all relevant information can be found here.

begin mounting boards can be both from the corner and in the center.But the second embodiment is more complicated though and enables to put certain patterns, thereby further decorating floor.Still, if such work is used alone does not, then it is better to start from the corner of the room, with the farthest.

from correct mounting of the 1st boards depends on the quality of the entire design.Therefore, its styling is emphasized.After installing the sample at the place of production and the required marking both its end faces are cut at 45º.

further adjusted 2 panels, which are arranged parallel to the first.Their joint - strictly by its center.This depends on the length of the samples purchased.Perhaps it will have to do with only 3 - 4 rows.

Everything else - just in the same way.It turns out that the main problem - the exact layout and fit.Well, in the limit of time required for such hard work.

feature techniques "from the center»

Pre-need to create a layout of the boards.Match all - of their size, angle of placement.

This technology is much more complex, but it gives a number of advantages:

• reduced the amount of waste, since the crop can be used elsewhere;
• an opportunity to create a decorative pattern.Laying

usually conducted rows simultaneously in different directions.It is easier to control the correct assembly geometry and coating.

General Recommendation

spatial orientation of the boards should be selected based on the location of the window openings.If the daylight falls along the long sides of the products, the joints are hardly visible.