From what we can drain

Drainage from plastic bottles

main principles of the invention the drainage system, which will be an individual in a constructive manner, it is necessary to have the ability to design in the ability to forgive the necessary amount of water that can get into the system and correct the configuration selection as a whole on a plot.
To organize runoff and drainage lines for a variety of useful items.In the capable hands of their next life will be presented, and in everyday life perceived as garbage.These objects can be plastic bottles, bricks, stones, pieces of old and worn tire solution.
Is it possible to do drainage from plastic bottles?PET packaging is a lot that is unattended or creates littered impressions suburban area and the surrounding area.
Getting Started will be as follows:

• necessary to examine the soil relief, it is a fundamental factor in the organization of the drainage system.
• from a study of the relief, you need to build a water flow circuit so that it is similar to the principle of the river (riverbed and its tributaries).
• outline a plan on paper and the terrain, it is possible, to begin work with the earth.Observe the depth of the ditch - roughly the length of two bayonet spades.

Do not forget that the fertile top layer is recommended to store, removing and setting aside temporarily to another location.

Plastic drainage, works are carried out in the following sequence:

• Turning cork, laid on the bottom of the bottle tighter.
• Falling asleep bottles made so that the ditch was filled up to half the depth.
• layer of sod laid over the ground layer.
• Make ramming.
• Next, pour a layer of soil and covered with a layer of turf.

This design differs durability and convenience.The advantage is that PE does not rot, which makes the system virtually eternal, and with the ability to make a flower bed or on top of the path, allowing you to save precious land area.

Stone and fascine drainage

Plastic packaging is not only the material from which it can be draining.For the production of fascines, can be used firewood, which is excellently suited.In use a sufficient amount of material that can replace gravel during installation.Options for replacement, not a single application of proven:

• fascines.Relatively long stems and twigs, which are connected in bundles with a diameter of about 30 cm. Viscous best done every 50 cm of nylon cord or wire.Longer stems stacked in the center, and they are shorter - along the edges.After laying on top of decomposed moss.Entrance to the trench is flared from the boards.
• Stone drainage is made the same way.Fascines replaced with gravel, which must be pre-sorted (close to the bottom, small walls of the ditch).On top of gravel is laid out with moss, then all covered with a layer of inverted turf.

Dehumidification without rubble

Manufacturing drainage without rubble, perhaps:

• Using pottery pipe with a diameter of 5 cm or more.When using pottery pipe joints need to impose moss or fiber material, which will act as a filter.Pottery drainage covered inverted turf and covered with soil.
• Zherdyanaya system.Use a wooden chute to replace the pottery pipe.The rest of the process is similar.
  

  sure, we must remember that packing should be taken to the top of the drainage system of the mouth, ie in the opposite direction of the water course.

• tide, made on the basis of poles.It called wooden system to perform necessary coniferous trees diameter, which is 7 - 10 cm. They must be cleaned of bark and sanded, and then placed in a ditch.

Therefore, we examined three methods of construction of drainage without rubble.

Drying with the use of modern textile materials

Production of soft tissue drainage of technological materials.The modern design are Quake membrane properties, the point is that the moisture is passed in one direction, in the opposite direction does not pass moisture.

to perform will be needed geotextiles.It forms a filtering layer that will prevent the ingress of debris, soil and sludge in the outflow system.This drainage system is as follows:

• digs a ditch, the slope of which coincides with the direction of the drainage.
• At the bottom is necessary to lay Tekton, so as to form a U-shaped appearance when viewed across.
• Next is a layer of geotextile with a clearance of 40 cm on both sides.
• Matter is filled with small stones or gravel.
• geotextile edges are wrapped.
• The whole structure is filled with soft sand drainage.

The article discusses various ways to drain your hands, you are given to choose the appropriate way to the drainage system.