The gable roof with his hands - the rules of calculation and installation

masonry gable - that we have to build?

Height gable wall defines capacity attic.The main objective of this design - the protection of the attic and the roof from moisture.Pediment must be reliable and robust as performing the function of support for the roof system.And, of course, he decorates any building.

Before you do the gable, you need to know what kind of material used for its construction.The material for the construction of this part of the house, as well as its design will depend on the technology, on which the building is constructed.If it is an extension of the outer wall, it may be made of the same material from which the building itself is constructed.

Pediment may also be a separate structure.In this case, it can be built from metal or concrete poles or wooden vertical beams.Then this design sheathe any material: siding, cladding panels, blockhouse, decorative trim, and so on.

Do not forget that the structure should be strengthened, because the strong headwind she experiences a heavy load.

installation and the necessary calculations

This article will consider how to establish a pediment, on the example of the brickwork.Before the start of its construction, it is necessary to know how to calculate the area of ​​the pediment.To find out that its height and width.If it would be in the form of an isosceles triangle, the calculation is performed by multiplying it by half the height.

Before you calculate the pediment need from corner to corner to raise it to two or three rows of brick masonry.This is done for the smooth installation and fixing mauerlat and right summing inclined trusses to gable.If this is not done, mauerlat and rafters will act for him, and it will create a serious problem during installation of the roof.

pediment roof with his hands - the main stages of installation

pediment begins with the markup.If it will be in the form of an isosceles triangle, then a penny wall is fixed wooden rake, the length of which should correspond to the height of the gable.From the top of the rack to the corners of the walls stretched nylon cord.

Thus, should get an imaginary triangle, where the upper end of the rail - its top, the wall - its base, and the nylon cords - his hand .If it is shaped like an irregular triangle, the rail must be moved in the desired direction.

masonry gable is as follows: first you need to try on a brick without mortar, that is, leaning to his stretched lace, make a mark and cut off his angle.This is done in order to design the gear did not work.When cutting the need to take into account the thickness of the masonry joint.In the cord should be cut the pediment over the entire thickness.

this way it is laid up to the top, after which the sides are aligned solution if necessary.That he was stable and reliable, you need to know how to strengthen the gable.To this end, reinforcing mesh must be placed every four or five rows of brick masonry.To give it more stiffness, perpendicularly inside the attic floor is elevated firming wall.

Once erected gable with their hands, you can begin the installation of the roof.We must remember that it is one of the most important elements in the construction of the house, so to its design and construction should be taken seriously.