How to choose laminate flooring - get acquainted with the main recommendations

How to choose laminate flooring?

When this coverage is important to take into account, for which room it is intended and what will be the operational load.According to the European classification of laminate is divided into the following groups: 21, 22, 23, 31, 32, 33. Thus, the 21 class is suitable for premises with a small cross - bedroom, office.22 class is also designed for residential, but with a greater load - living rooms, children.23 class involves the use of the coating in the hallway and in the kitchen.

31 class is suitable for public buildings with a small cross (a conference room or a small office).Class 32 is designed for a floor with an average operational load (reception, office, boutique).33 class is used for buildings with high traffic (shops, shopping centers, restaurants).Also, when choosing a laminate coating should ask Taber test (number of revolutions).Typically, the figure ranges from 6,000 to 20,000 vol.This value indicates the strength, durability, resistance to light, moisture, etc.In fact, this is one of the main parameters.

How does the Taber test carried out?On the front side of the material is applied a special grinding wheel.So, the number of its rotations to wear the protective top layer is the main parameter.But when you watch this number on the packaging, it is important to pay attention to one point.Symbols can be: IP (initial phase), FP (final phase) and AT (arithmetic mean).And not all manufacturers indicate three digits at a time.Some unscrupulous firms represent only one of them.Be careful!

Make laminate flooring: A few words about the preparations

Well, the stuff you bought, and it is time to carry out the coating laminate floor.But how to do it right?For this we represent to your attention a brief statement.To get started is to prepare tools and materials.Sam laminate must lie for 48 hours in the room where the installation will, so to speak, "get used" to the microclimate.The air temperature should be about 18 ° C and humidity not exceed 70%.But note that the package is not necessary to disclose the laminate.

They should be closed.Only when the laminate floor finishing will be done, you can open it and check the contents.Defective tiles can not be laid.Next is to prepare all the tools: boss, hammer, saw, pencil and ruler, wedges, clamp, plastic film, the substrate (you can cork).Then it begins flooring on level ground.Possible and laying laminate flooring over the old, if it has no cracks, potholes and defects.

How to strengthen the laminate flooring?

After preparing the materials begins floor installation of laminate.The basis for this must be leveled with a concrete screed.Sam flooring tiles is important to start from the window so that natural light is parallel to the seams.If you decide to make the seams perpendicular, keep in mind - they will be more clearly visible.Thus, any defects and curvature lines are also visible.Then when you start to form a laminate flooring with your own hands, do first the first row of the 2 boards.

While most laying between the tiles is important to establish wedges.They provide a gap, which must be equal to 7-15 mm.After shrinking the coating can easily "narrow" or "expanded".If you do not think about the gaps, then, in the end, the laminate begins to abut against the wall and wake up "on end."When issued the first row, you can proceed to the second.Rods are connected to each other with a locking means.The difficulty is not there.Thus, row upon row of stacked cover you.

Note further operation! floor design of laminate is that it is better to avoid excessive contact with water.Wipe dry or semi-moist coating cloth.