How to put plywood on the floor

What you need to put plywood on the floor

In order to begin work on laying of plywood on the floor, you need to prepare a number of tools and materials:

• plywood sheet.
• wooden beams.
• fixing material.
• level.
• Drill.
• Sandpaper or sander.

How to style your plywood floor:

Action Plan Work on laying the plywood on the floor consists of a number of incremental activities:

• Adapting the material to room conditions.
• Surface preparation before the floor installation.
• Laying lag.
• removal of irregularities.
• Attaching the plywood sheet.
• Finish veneer coating.

Laying plywood on the joists: step by step instructions

Step 1: preparation of plywood for mounting on a wooden floor

After the plywood sheet has been bought in the hardware store you need to give it to adapt in the room in which will be heldconstruction works.The fact that a tree - a material spatial parameters of which depend on temperature and moisture parameters of the room.Therefore it is necessary to take the form of plywood, which corresponds to the temperature regime of the room.

Step 2: Preparation of the wooden floor in front of finished plywood

Before laying the flooring of plywood sheet must be prepared to work surface.If this is a dirt surface, it is necessary to remove the top layer, then fill up with dry soil and a layer of gravel.Then thoroughly compacted.If the surface of the concrete, then it must be cleaned or perform an additional layer of screed.

Step 3: lag under the plywood mounting

Laghi is a wooden beam, which serves as the basis for the future of the flooring of plywood.They are laid on the floor perpendicular to the light emanating from the windows.Between the wall and joists need to leave a gap of about 25 mm.

Step 4: Preparation lag

Each lag should be checked for flatness using a long line and level.Upon detection of irregularities to be removed, by placing wooden logs under the lugs.

Step 5: Put a plywood floor

Before laying the plywood sheet surface must be cleaned between joists.Then use the anchors must be secured crate.After that you are ready to mount a plywood sheet.plywood sheets must not touch each other in order to avoid squeaking.The gap between the sheets should be about 0.2-0.4 mm.

Step 6: finishing plywood flooring

After installation, you must clean the surface and treat it with primer.Further coating material can be made to taste host.This can be linoleum, laminate flooring, carpet, etc..

Thus, the article described and characterized stacking process plywood floor.