Instructions for self- repair toilet cistern with a button

It just so happened that almost all who dare to install a toilet-compact, having a lower water supply - the people, tired of the long-term observation of corroded water pipes and sewage systems, and pretty frequent meetings with plumbers (most of which are very oftendrunk), repaired the ancient (mostly early Soviet-made) toilet, and very naive to believe that the installation of the new toilet will help get rid of all these problems.However, the calm lasts very long.

Already after a few years, and sometimes even almost immediately after installation, the system begins to "show off" somewhere starts to leak water, or not typed into the tank.And then, when there is absolutely no desire to once again appeal to a sanitary service, slipping little thought that would be nice to try to understand the toilet on their own device.And it's true, the device drain the toilet tank is absolutely nothing complicated, although toilet models, as well as tanks for them, a great many.Despite this, nearly all of them are composed of the same set of components.

absolutely any of the toilet tank is a tank of water, which is covered with a lid.In order to remove the lid from the tank in order to see, you must first unscrew the button responsible for the discharge of water.These keys are usually handed turn away quite simply, without the use of tools.Sometimes, of course, that the button does not turn away.This may mean that the button is mounted on the cover gidroshnure and in this case will be neatly removed without loosening the button.

Another reason for the leak of a tank can be depressurized float as a result of his injuries.If a check has shown to this cause, it is necessary to change the float.Temporarily, you can restore the tightness of the float using a sealant, removing previously fallen into the water there.

If the tank is constantly flowing, and water is poured into the bowl, then the reason for this, most likely, may be unserviceable membranka which have included siphon tank.To remove the old and install the new membrane need to release all the water from the tank (cutting off its supply) and attach with wire float lever to the bar, set the lid in place.After that, it is necessary to unscrew the nut that connects the tank to the flush pipe.Then he pulled out and disconnected the siphon.You can then change the membrane and gather (in reverse order) all fittings.

It so happens that the water in the tank flows too little or a lot.This fault is corrected by using the float adjustment.To do this, remove the reservoir cap, move the stop of the float so that the float has stayed above or below.Thus it is necessary to achieve a normal level of water enters the tank.

If the problem had to sever part of the tank, before the assembly is lubricated with silicone grease thread connections.After that, it is necessary to test the assembled structure: supply water and ensure the normal operation of the entire device.