Laying laminate their own hands

Stages

There are several ways of laying the laminate, but they all have some rules that need to laminate soblyudatklast own hands:

• Do not use this material in wet rooms, so it is best to pick up some stuff for the bathroom.
• floor must be dry and hard, and smooth.For standard takes the following characteristics - height difference of not more than 3 mm per square meter.
• on the concrete floor you must first lay a polyethylene film on its substrate material, and only then put the laminate.

right to lay laminate should be adhering to the following technologies:

1. The substrate is necessary to lay strips without overlapping.The joints are connected by a simple masking tape.

2. Boards are stacked in two ways - perpendicular to the wall at an angle.The choice depends on the design idea.However, it is worth considering the important fact - laminate should be put in parallel to the light source, otherwise the joints will be visible, but it does not look very nice.

3. It is necessary to ensure that the seam of the debris did not get

4. Laminate own hands can be very easy to put on a large area without interference, but it may be difficult to difficult areas, such as near the door or on-site location of the pipes.Option with the door will be simple, if it is not installed and the surface is flat.If the door is already there - you need to cut it out in the shape of the door frame, but very carefully, there should be no gap.With the pipes need to limit the location of their passage.The first thing you need to drill a hole, and then fine-sawing from the center of the hole to saw.

5. The material can be placed on one board, while they are fixed to each other over their entire length.Attach it so that it is possible, if the work is done by one person without assistance.

second rule laying laminate - is mounting strips.Fastening occurs along the narrow end faces, rather than wide, as in the previous method.

This is the core technology for installation of laminate.The other, as there are none.Except for quite problematic area for stacking, but in this case nepotnym human work is not carried out, and hired a team of specialists.

Tools

tool list is quite simple:

• Saw
• Hammer
• Bar damping or scrap laminate panel.
• Sawing with a fine tooth comb.Also suitable jigsaw.

Laying laminate - it is easier than it might seem.Execution of these works did not take long, and the result will be a beautiful truth.After all, this material can be applied in virtually any style of an apartment or house.The most important thing - it is not to forget the plastic film that acts as a waterproofing and put the substrate properly.Buy all materials can be in one place, which is also a big advantage.Put your rukamibudet laminate is not difficult, if you follow these rules

should also be said about the floor leveling - it is necessary to remove all the layers which existed before, and get to the concrete base.Clean place and start a project.The floors are made of laminate can be used in the living room, bedroom, dining room.But do not use this method the floor covering in the kitchen or in the bathroom.