Handyman to help - a workbench carpenter with his own hands

From which to build a workbench carpenter with his own hands?

When you came to the unequivocal conclusion that no bench you in any way, just have to decide to knock together it is called a "from scratch" from lumber, or use as the basis of some ready-table (or part of it).The latter option is useful, but not every piece of furniture suitable for work bench, for example, the kitchen table to shatter rather quickly.

If you want a bench without much effort, it is best to use an old desk, and it is desirable that it was not made of chipboard and the array.

ideal variant - a table with the side tables.Even if its top in particle board, it does not matter, we can replace it with a more suitable.Take Planed bars section 30x60 mm and a length of 1.5 meters, in the amount of 30 pieces (can be more or less, at your option), each carefully oshkurivaem to a smooth surface and glue one large shield assembly.

Its surface ostrugivaem and again oshkurivaem.Bottom anchoring the cross members of these bars, bolted screws for each board member.Veneer can not paste over just laid on the basis of the desk and anchoring areas.But of course, this is not the bench, but only blank.It is necessary to make a number of additional tools in order to be able to start working.

homemade workbench, when the basis is nothing to take

average height - about 180 centimeters, therefore, need to put together a bench about 94 centimeters tall.However, you make a workplace for themselves and, therefore, the height should be adjusted to your height.For the legs use the bars section 10x10 cm, connect them to each other in the cross members 2 tier, lower mounted at a height of 10 centimeters from the floor, the upper level with the tops of the legs, to get a basis for countertops.

As for joiner's board, we have already explained how it can be done, that came to a simple embodiment, is also suitable for complex assemblies.Among other things, homemade workbench can be implemented and drawers for this under the upper cross members fit runners, which are used to sliding boards in the computer desk, only this time on the rollers will be nominated by the boxes in which you can store drill, nails, screws and other trifles.

So workbench is almost ready.We can only make it more soundly, further strengthening cross slopes. countertops should be laid on the substrate, ensuring that it is put forward in front of the frame edge to 10 centimeters on each side - at 5 or 6 .It is necessary to install and vise clamps.Fasten wood panels to the upper cross member and the tops of the legs areas, to work on the surface did not screw caps.

think through drawing bench

Actually, not even drawing bench and countertop layout, placement on the work surface of all the necessary tools to work.First of all vices, they should not interfere, so install them on the left if you are right handed, and on the other side, if you are used to work with his left hand.Also vise on the workbench you must place multiple gussets, that is wedge-shaped cut-outs in the countertop imposed on boards .These stops are combined with vise provide better handling workpieces.

If you are working a jigsaw, it is useful to the bench priladit vypilovochny table, he is carried beyond the edge 20 centimeters and allows more even cut through the plywood.To produce such a table in a board width of 120 and 250 millimeters on one of the short sides make a wedge-shaped cutout in the widest part of 50 millimeters in the corner drilled hole with a diameter of 1 cm.Secure the tablet can be screwed, or you can make it removable, to connect with a clamp.The same principle is focusing for the boards on the workbench surface.