The seal the gap between the logs log .We select the sealant .

The seal the gap between the logs - look at traditional materials

When it comes to finishing the joints between beams or a log, only one literature is not enough, since a dozen books provide for your consideration as much konopatki options.Of course, deliberately false information on the directories page is rare, but it still happens, and it is quite difficult to identify, among other data.

most reliable advice on what to close up the gap between the logs will give only an experienced master, or at least people to test in practice what he is talking about.And, interestingly, many agree that the moss is one of the most effective materials for caulking.Often, on the outskirts of the swamps you can see a carpet of sphagnum, which, while still wet, easily stuffed in the joints between rims.

Qualitative can only be called such konopatku at which a sharp awl enters into the gap between the logs is not less severe than in wood.

more common and the same eco-friendly way to seal cracks - filling them with oakum smeared with plaster or cement mortar, or just ramming it accessible to all consumable without any additives.Instead, you can use hemp or jute fiber.The difference between hemp and hemp insignificant - the first is derived from flax, hemp less, the second is only obtained from the hemp.

These materials are used by our ancestors, and so today they will prove just as good.The only thing that may create discomfort, it is if you suddenly need to saw a new window or make another opening for okosyachki, use the chainsaw will be difficult - and hemp tow chain and hammer blunt it.

Modern putty for logs

addition to natural materials for the sealing of joints between rims log (some of which do not even need to buy enough to go into the forest or swamp) modern industry can offer a lot of synthetic.On the ecology is there to say no longer necessary, but the reliability is definitely observed that from the likes of caulking, in fact, required.

Some "experts" advised to use silicone sealant, but this method of jointing only aggravate the situation, because the wood has a tendency to absorb moisture, and if it is somewhere will evaporate less, there will almost certainly rot is formed.

In stores you can find a lot of special sealants based on polyurethane, which is not afraid to ultraviolet radiation and temperature changes.This putty for logs suitable for grouting both outside and inside the carcass. In no case do not use polyurethane sealant in cylinders because they are mostly "do not like» sunlight.

Important: for grouting needs enough elastic material, as wooden house "breathes", it absorbs moisture and releases it is heated and cooled, as a result of all these factors, there is even a small, but constant progress logs.Under these conditions, the same foam burst just a few months.

How is konopatka and laying between the logs?

Before you seal the joints between the logs, think about what you will be under the putty.The fact that the full score gap sealants impractical and uneconomical because they can be quite deep, and in the wooden house of the joints, there is usually at least 40.

Therefore, you should immediately make a decision, you will use natural or synthetic filler.Natural materials for caulking we mentioned above, with regard to artificial, many masters agree that it is best to use a cord of polyethylene foam, it can be of different diameters can be matched to the width of the slits.

scoring with a maximum density of seams, begin to cover konopatku sealant.To start glue on both sides of the slit masking tape, so as not to stain putty all log .If the installation logs or timber you used a felt gasket between the timber (such as a layer of moss, some recommend, glass is better not to use), fill the gap breathable material such as tow.

Now as most of pack: it can be done with your fingers, but it will be ugly, better to use a special rubber spatula for joints, which has been used successfully by applying grout for a tile.To finally close the joints, you can pin the flat strips, which fit perfectly into the overall design style of the log house.