Angle nozzle for screwdriver - where and how to apply for the tool bits ?

What types of nozzles are available?

Standard screwdriver bit is a hexagonal rod, one side of which is a work profile, and on the other - tail for mounting in a chuck or spindle tool.double-sided bits is also actively used, in which both ends are working profile.For example, this may be a straight profile in combination with the profile Phillips .If you are a long time working with fixture of the same type, you can use a double-sided profile, but with similar profiles at both ends.Bilateral packing is often produced with an elongated shaft.

Along with them, also presents tips for special purposes.These include, for example, refers to the bit spring retainer which comprises a spherical hexagonal profile, so-called angle head.This tool lets you tighten / unscrew the screws at an angle of 30 degrees with respect to its axis, which greatly simplifies the work in remote places.These nozzles are often the only way to significantly facilitate and speed up the work with complex designs.

Note!For convenience and interchangeability introduced standardized sizes and shapes of tails.Thus, the most common standard - is 4.1 inches.

The right choice - the key to success

Bits for the screwdriver is necessary to choose correctly.So, there are tips for manual and electric tools.Externally, they can be distinguished by the presence of the tip and tail of a special section, which is necessary for depreciation shock.These bits are called torsion.However, these tips are only required for frequent and intensive work and for occasional use should be fine and the usual bits.Quality Corner are made of good metal, which enables them to reliably serve a long time.

How well a particular approach to a particular bit of the corner screw is determined empirically.For this purpose the nozzle is inserted into the slot and check the contact strength of scrolling.If it sits tightly and without gaps, so it fits.Otherwise, scrolling will occur in the screw heads, which leads to rapid wear and bit "licking" splines.Nozzle on the screwdriver for drywall is selected in the same manner.

Important!Wrong choice of the nozzle will have an effect on what will increase your cost of buying new bits.

Angle Head screwdriver

Angle heads for screwdriver made of different materials.Thus, a set of nozzles for the screwdriver bits may not only have different shapes, but different material.Standard materials are:

• Special Steel Tool R7-R12, which has a high degree of resistance to wear.It used to work with an incandescent materials, but quickly collapses into contact with the hard rock;
• win;
• Flint Magnesium spec.It is very resistant to working with all types of metal and mineral, concrete;
• Tool steel alloy pobedita;
• special attachment strength is obtained by deposition of titanium nitride.

good corner nozzle must have a metal gearbox and housing.Reducer is better to choose a precision, since it allows you to work accurately and comfortably.Recommended nozzle height should be at least 50 mm, which will give the opportunity to work in the most remote places.The best grip is the one that rotates 360 degrees for easy operation with both hands.

Note!For work in tight spaces is a two-step tail useful tool.