Welding wire for semi-automatic - part responsible for the success of

machine settings and their elements

All semi-automatic can be distributed among three categories: portable, mobile and stationary.The first two types can be used anywhere.Welding machines consist of the following components: a connecting hose, control unit and the semi-automatic welding wire feed torch, a power supply or a transformer.

In some devices, the primary power source inverter rectifier.When the machine has a pulse mode, he, in conjunction with inverter rectifier, welding makes the product a very high quality.Some expensive models are equipped with a memory function.

wire welding semiautomatic happens in the following sizes: 0.8 to 1.6 mm in increments of 0.2.metal type and its thickness will determine which wire diameter to be used in each case.The instructions usually have a table that will help establish compliance with the terms of these parameters.

What you should know that the weld was successful?

Now consider how to cook semi-automatic welding.Take the terminal device and connected it to the workpiece.Since the wire is fed device, you need to decide how fast it will be supplied.This will directly depend on the characteristics of the sheet to be processed.

Before starting to work, pay attention to what type of metal you need to cook, and what is its thickness.Now we put on a face mask or hold it in your hand in front of him and pulled the trigger feed.As soon as the welding arc, conduct derzhak on the desired route.

What is needed for semi-automatic welding?It is necessary to determine whether the wire speed is adjusted correctly.A little "chef", you can see the result.Clots wire and extremely loud noise will be evidence that the rate is too slow, and if the high speed, the spread of droplets occurs.

In these cases it is not necessary to press on the wire, as it will be subject to strain, and may occur more unpleasant moments.Also, the seam itself is defective.In turn, a small crack during operation, sound evenness and smoothness of lines tell us that speed is chosen correctly.Experience in the work will serve as a reliable assistant.

Basic rules for the use of the welding semiautomatic

happens that while the metal begins to burn.Why?The reason may be too large supply of gas, it should be reduced.The presence of pores in the seam of said supply of gas needs to be increased.In words, you can not always explain exactly how it works on the welding semiautomatic practice video review in more detail and clearly show the work process.

Includes manual welding semiautomatic.It is important to carefully study it and remember because, before you get started, you need to configure each device.

to work welding machines was safe, it must be remembered intuitive rules of operation of such devices.Here are the main ones:

• When using this product, make sure that there is a ground control unit.Also to be grounded power supply - transformer for semi-automatic welding.
• forbidden to work for people younger than 18 years and have not undergone special training and instruction.
• semiautomatic work on it is strictly forbidden at any malfunction.
• rooms where work needs to be ventilated.
• repair apparatus can produce only those who have access to these works.
• If the pause, the unit must be switched off and stop the gas supply.

Also, in addition to the above requirements, you must always pay attention to the instructions on the unit.