Ways to defrost pipes : hardware and hand

Freezing sewage occurs

reasons for freezing the water in the water there are a few:

1. If you had not been followed to the depth of sewer communications facilities.
2. lack of insulation systems.
3. If the house has no heating.

defrosting methods

hardware.This implies the use of industrial devices ottopleniya ice.It is used for metal pipes and plastic for the device completely ineffective.

on communication attach special tongs that are supplied electricity.Then, the pipe starts to warm up, and therefore, melt.No specific device model that you should definitely choose as they all have about the same price and efficiency.

Typical properties:

• power consumption - standard.
• Power Output - 300-400 A.
• current supply 1.8-4 kW.
• Performance: 1 hour - 23 m pipe.

To defrost water drain and water supply system must provide the fluid pressure.

Defrost other ways

The aid may come such items:

• Gidrouroven construction
• Steel wire
• capacity to collect water.
• mug douches.

should use this manual to defrost plastic products.Wire align and connect it to the level of the tube, which is attached to the end of the mug Esmarch.Then made the design carefully placed into the sewer and run into it a little hot water.

As soon as the hot water will be poured, will follow the ice melted.The reason for this is the physical process of displacement of cold water hot.Capacity for flowing water is prepared in advance.The easiest way to heat the composition pipe, so it does not need special installation and pumps it.Water flows off easily from the system.

heater for heating sewerage

First defrost as the sewer, you must create a device:

1. Securing PETN on the plane.
2. Bend device must act on the edge of the board.
3. All parts of the device may not exceed the board and not be in contact with the tract walls.
4. to defrost ice jams require a certain length of plastic pipe, which will be the pusher for cork.

heater is connected when it is in the tube and, as the water will melt and flow down, it should be turned off.

As thawing pipes: no written rules

1. Frozen section can not be abruptly heated.
2. to allow the water was normal flow, open the faucet plumbing.
3. ottayaniya procedure should begin with a supply tap, and end at the site of the riser.
4. Cast iron pipes should be warm, moving from bottom to top of the riser.

In the future, that you did not arise from the question of how to unfreeze the sewer pipe, if you intend to build the sewage system in the house, remember that the freezing of the pipes for it is invalid.Therefore, be sure to lay the communication on a certain depth to them depending on your region's climate.Also do not forget about insulation!So, using insulation materials, wires and insulated pipeline.This will ensure uninterrupted operation of sewage and avoid the freezing of the pipeline.And, of course, good luck to you!