Facing ceramic tile stoves - practical and aesthetically pleasing

Why you should choose this material?

for quality and long-lasting masonry is necessary for correct use of the process and the correct proportions of binder solution.However, equally important to choose the right tile.Good ceramic tiles for cladding the fireplace must have the following characteristics:

• strength.Ceramic tile has a high degree of strength, much higher than that of cement and concrete;
• Rigidity.Tile is not subject to deformation even under heavy loads.The thicker it is, the higher its hardness;
• Fire.This material is subjected to very little thermal expansion, which makes it possible to use it for lining furnaces and fireplaces;
• Environmental cleanliness.Upon heating of the tile no toxic substances;
• heat.The material transmits heat perfectly.

addition, ceramic tile does not fade and does not lose its Kolor with time, which makes it an excellent material for decorative ornaments.It is well cleaned and washed.However, the furnace tiling will affect your budget as it is an expensive material.Since it has no sense to buy cheap tile because it spoiled quickly, and not everyone will be expensive on the pocket, the choice is yours.

Note!Though expensive, this material remains the most popular and high-quality way of facing a heater in the house.

Facing ceramic tile stoves starts with the preparation

lining furnaces with their hands starts with surface preparation.To do so, it removes all the dirt and dust.If there is old paint, it must be cleaned.After that, all the seams are stripped by ten millimeters deep.All dust, debris, clay is removed with a wire brush.

The adhesive can be applied in several ways.The first - is to use a grid with cells for spreading glue.This grid is tightly stretched and hammered nails into the seams.Also in the seams, you can lay the wire, which will be attached mesh.The second option consists in treating the entire surface drill pobeditovym a half a millimeter deep.Then screwdriver screwed screws, which are tensioned mesh-Ryabitsev.Thereafter, on the surface of any adhesive is applied.

Important!The presence of the grid provides good and reliable fastening of the tiles, it is recommended to use it during the laying.

Perfectly suited for such purposes, adhesive cement-based.It includes special elastic contains additives that prevent deformation to occur at different loadings.Once the mesh is stretched, the entire surface is equal.For this purpose, glue is applied with a spatula on a mesh.If the surface at a time could not well aligned, it must be repeated.After the wall was able to make a smooth, you can start laying the tiles.

process

masonry stove lining begins below.To get straight stitches, use crosses.When the tile is applied, it is necessary to squeeze his hand, and at a large scale and still incite a rubber mallet.Remains of the solution should be immediately clean.As you work, it is important to always check the level and accuracy of the placement of the tiles, so how to fix something that is not possible after the drying of the adhesive mixture.

day after laying begins filling the joints with a special solution for grouting.Seams are filled with a spatula, and any excess solution removed.After that, clean the surface with a damp cloth and a couple of hours after work, you can start the final cleaning.For this purpose the flange cloth soaked in a special solution to remove the cement film.

Next formed concave seams and polished with a damp cloth.Facing Russian oven can be made with rustic tile motifs, and is perfect for a modern painting for the fireplace.Facing tile kiln, video phased process which can be easily found and see performed simply.

Important!The seams must be made within three to four days moistened with water.