How to wash iron battery - and again helps us to chemistry !

How and why hammered cast iron battery?

What batteries pollution is the reason?The water quality over time leads to the fact that the heating settles a lot of mechanical particles.Small wire and the like with the water circulates through the heating risers.In the non-heating season the water is usually drained.This leads to the fact that pockets are formed of corrosion in pipes.

hot water is fed under pressure to exfoliate corrosion particles, and they are also deposited on the batteries.And the water itself, to start up the heating system is often not clear.This accumulation of diverse materials in cast-iron heating systems leads to the fact that they absorb years of rust waste circulating in the system and the battery is clogged.

Over time, this affects the quality of heating.Even with the good heating cast-iron pipes, they can only be warm or slightly warm, even hot riser itself on its own.If this happens, it is a sure sign that the heating system is clogged and must be cleaned.

How to clean iron battery - answer gives household chemicals

Since this difficulty does not shy away from a single person, a look at how to clean cast-iron battery.If you do not take into account the weight of the object, the work of cleaning is not complicated.There are several ways of how to clean the heating system.Of the following, you can choose the best option.Clear

battery from debris by using soda ash, means for washing the car radiator, buttermilk, vinegar essence, and in many other ways.

Cleaning cast iron batteries begins with their removal.Moreover, if they do not have many layers of paint, they can be dismantled into smaller sections to make it easier to handle.Do this procedure must be in the season, when the apartment is not heated.

One way is that the hot water poured in the usual soda ash and poured into the heating system.Thus both ends of the heating system must be installed plug.The battery can be shaken, and after a short time of about one hour to knock around the perimeter of the wooden hammer to adhering to the walls of rust detached.

Then open a cover and sum up the hose, pre-connected to the water supply.Open the second plug and open the valve.Just make a big push to pressure as much rust came from the battery as possible.If at your disposal there is a compressor, you can use it to create more pressure.

creative approach to cleansing the battery

Flushing iron batteries can be made by means intended for washing the car radiator.Before you pour the means to the heating system, read the instructions on the necessary dosage for a particular volume, and observe it.

So pour money and added to the hot water, but not completely filled battery.Within two hours of battery sections need to move to 10-minute intervals.After this time the radiator is washed with water and a power in large numbers to no more corrosive particles.

How to clean a cast-iron battery buttermilk?Serum is poured into the battery, and, as with soda ash cleaning, heating rolls and rattles that serum was agitated.Acid in serum, rust and corrode purify your heating system from it.

To further reduce the amount of rust on the battery, it is possible to take a small inlet of the tip of the tube with a stopper and put to him the magnets.The magnet will attract rust and will only occasionally open the cap on the tip of the tube to remove the corrosive particles.