We make it convenient to stand under the phone with his hands

Cell phone today almost everyone has.So I have, but not one, but two.And there are two "amateur" most of these phones are not age-developed and interesting.I usually come home, tidy phones so that they reach them they can not.But if you need to put the phone on charge, the difficulty begins.Be sure someone and tries to step on or sit on the phone.You can certainly buy a cradle for the phone.

But, first, you spend your time and money searching for the stand, it is better to do it yourself, and, with it pretty quickly.Secondly, I would like to stand with the phone has also been out "dostavaniya zone."In the sense that children do not "get" no phone, no, in the end, my wife.And thirdly, its "magic" words, "Well, you can do all things? !!!" Instilled in me the enthusiasm.

Make a stand for mobile

On the Internet a lot of different advice on this subject.As they say, who on that much.So I carefully reviewing all, did as I prefer.I decided to make a stand "tall" that was at the outlet level and children can not reach it.The basis took a bottle from under the phytotherapeutic shampoo "Clean Line".Is focused on the best of our three dimensional cell (my two and one wife).We bottle the width of a little more than 7 cm, height - 20 cm, so it turned out exactly what you need.

top of the bottle, I just snapped.Then the resulting case thoroughly laundered from shampoo residues and dry.Then - marking.I attach the phone to receive the case and said the height of the front wall.I make it so that was visible to one-third of the phone.But as a model already took the smallest mobile phone - wife.

felt tip at the front and at the sides outlined the cutting line.Side - to the middle (width).It remains only to take a paper-knife and carefully cut off the excess.It so happens that the front wall by more than half the height of the case had been "eliminated".

There is one caveat - the power cable is connected to the phone side.Therefore, as from one side of the case I made a wide neckline and slightly lengthened it.Calculated to the phone with a cable connected well placed in the stand.The top of the back wall of the case, I gently rounded large pair of scissors.

now - a place for installation of the charger.The idea is this: the plug "charger must" pierce "case (back) at the top.And then, together with the case and its integrated phone charger plugs into a power outlet.I marked out a place for the holes to the pins of the charger is easily included in the wall of the case.Then he picked up the drill by 3.6 mm (which was handy) and drill the hole, that's all ready.

remains only to process the resulting edge of the stand - suspension and holes.I did it with the help of a file and fine sandpaper.My wife started to come up, than it is now pasted stand for beauty.But on this matter for advice - to her.And I have my work is done, and convenient mobile phone holder is ready.

In the video you can see one of the stand manufacturing options: