The ceiling of plasterboard with backlight

plasterboard backlit fairly universal.The surface of the building material as drywall is almost perfect.It is also known that the material is flexible, and this enables designers to create a most unusual shape.This makes it possible to make a two-level ceiling.Even not very experienced master to do plasterboard backlit own hands .Before you start to work should make a plan and detail to consider all the details of the design.If your housing area is large and the ceilings high enough, it is possible to mount the multi-level ceilings.Typically, first make a sketch.After that, the calculation of the necessary materials.Usually it sheets of drywall, profiles, fasteners, etc.

Mount Technology

single-level ceiling installation is quite simple.It is more difficult to install LED lighting ceiling plasterboard.With the construction or laser level on the perimeter is set zero or zero point.By marking the lines guides attached profiles.With hangers mounted rack profiles.With mounts for crab-strength design further strengthened by longitudinal profiles.To further strengthen the structure can mount longitudinal profiles duplicate suspensions.Before you fix the drywall sheets should be on top of the frame to hold the wiring for future lighting.

to the profile with screws installed drywall sheets.Caps screws must be fully recessed.Further, the gaps between the sheets shpaklyuyut.after the plaster hardens the surface sanded.The diode illumination of a ceiling for the single layer of plasterboard ceiling is quite simple to install.First of all, for the lamps to do the layout and cut the appropriate holes.There are circumstances in which the holes are cut out after installation of drywall sheets in the right place.In this case, you have to be very careful.In the process of cutting holes can damage the wiring.

Video instruction

Setting the backlight of suspended ceilings made of plasterboard has its own peculiarity.The cable must be routed only in specialized sleeves or cable channels.Safety is strictly forbidden to place the cable in the profile or on top of them.In order to in-service cable is not frayed cables can not be accommodated on the sharp edges.Sam sleeve should be sealed.Otherwise, when moisture may short circuit.Moisture can get as a result of unforeseen circumstances, such as a result of flooding neighbor above.

If you have mounted a multi-level ceiling, it is possible to mount a hidden ceiling illumination of plasterboard.In any case, if there is a danger of the emergence of high humidity, or you are not quite sure of your neighbor, who lives on top, you need to take care of additional protection measures.Wiring harness has to be hidden in the terminal boxes.It should be taken into account when selecting the cable total load power.Switch better placed at 100 mm from the floor, and it is important that it does not cut off the zero and phase.In the future, it is useful when replacing light bulbs or LEDs.We offer ceiling photo of plasterboard backlit .

Photo plasterboard ceiling with lighting