Garden parquet floor - how to put ?

Garden parquet: a short description, and the scope of

Decking is a square or rectangular section, which may have a hard or soft mount.Hard are made of hardwood and soft, made of a plastic substrate (lattice with anchorages system).By the way, this substrate provides the necessary ventilation and drainage in certain buildings (eg, baths).Once this coating is called "garden flooring made of plastic."

If we talk about the tree, the extremely popular garden flooring made of larch, because it is resistant to any external influences, hardness, durability.It is a tree in the period from V to IX century, was widely used in construction for the production of telegraph poles, piles, components for ships.This wood was not afraid of any weather, any time.

also in great demand enjoy the garden parquet thermowood (ash, oak, beech).Heat treatment is carried out at 210-220 ° C t in an inert environment.This increases the durability of wood (25 times) reduction of deformation (5-15 times) and better water-repellent properties.It is intended the coating those places where there is high humidity:. Garden paths, streets, garages, piers, outdoor areas, verandas, etc.

In general, the decking is used for gazebos, terraces, basement, cellar, balcony, porch, veranda,saunas, baths, areas next to the pool, bathroom and other areas.

Benefits garden parquet

Decking high environmental performance differs in comparison with the paving slabs.And when used in home and even "warm."According to it, a nice walk, and feet will not get cold like in contact with granite.But this is not all the advantages.If you list them in full, then the following.

• has a beautiful wood pattern, it can be installed in various ways.
• unpretentious in the care and maintenance, no need to think about how to clean and repair the flooring.
• Strongly not warmed up during the heat, in contrast to the cement.At the same time, capable of retaining heat.
• humidity resistant and does not rot.
• slip surface, so that even when the heavy rains there is a risk of falling.
• easy to assemble and dismantle thanks to a special attachment.

rules laying

If there was a question - how to lay parquet?That mount technology is quite simple, but the process takes much less time than styling of any other floor covering.Before proceeding to the floor decking, it is important to make a tie (ie, level the surface), which is necessary to build a special sewage water.Also laying can be carried out on the gravel-sand coating or rammed earth.

Next start to mount the square or rectangular sections, which consist of wooden planks (decking).Each section has a slot for better ventilation.The size of the gap depends on where it will be operated cover.Mounted sections on special supports which can be of different heights (unusually advantageous in embossed surfaces).Thus, they smooth out these fluctuations.

size of each section can also be varied.Most often, the producers themselves define standards.But the most common are considered 50x50 cm and 30x50 cm. positioning strap section can be straight or diagonally, it all depends on what kind of image you want to create.

Note!In those cases where the decking has been laid on the street, at the end of the season it should be disassembled and removed to a storage room.The next season his stack again.