Starting method of switching light .Main circuit connection of fluorescent lamps

types of fluorescent lamps

There are several areas to plug this device:

1. first area - a place where the light does not turn on
2. second area produces ignition in the cold cathodes
3. third is characterized as an area in hot cathodes
4. fourth uses a cold ignition, and so can include heated cathodes

main application of the scheme:

1. Very often used in the circuit with the band.cathode heating comes from certain hot coils of an electrical transformer, this winding device works in parallel.
2. scheme to include a heat exchanger.To change the current in the lamp, you need to change the power, or rather the tension in it, as well as the phase of heating the electric discharge.
3. also happens zapuskaniya resistor.It comes with Voltage unstable.This scheme is used when a small number of lamps.
4. essential factor is the regulation of light, which is done by replacing the current supply by the regulator.

repair lamps in case of failure

throttle is known for connection and operation of this device, you must know what and how it is attached.In this case of mounting device is a choke.They are used as specific elements.With these reactors is very often a problem, as due to the surge, they do not operate stably.

can buy a new cord, and just to change it, but the price for it is about the same as in the fluorescent lamp itself.If the financial aspect does not, you can make repairs himself.First we need to remove the protective cover and sertsevinku, or rather two parts.Remove the coil, if there is a problem with this help can take a knife on metal.And after all just wrapped a new throttle.

If you apply the copper coil, it reduces the diameter and is very easy to replace.In the rewinding of the device will take about 2-3 hours.It must be remembered that the great power cord it is easier to be installed and disassembled respectively.If the cord is small, it takes a lot of time, energy, and the quality is much worse.