How to unfreeze the plastic pipes on their own?

Defrosting with open fire

This method of thawing is widely used in the case where water is in the ground.Defrost process water system via the fire is not difficult to perform, but it requires a large expenditure of time.In place of a possible formation of ice jams, and a fire is maintained for several hours.As a result of these steps, gradually warming the frozen ground over communication and, thus, the system itself warms and defrosts the ice cap.This method is very good in application to iron materials.In case it may damage the plastic sheathing, which can lead to depressurization of the shell.After this type of warm-up is recommended to dig in the ground passing plastic piping for water and check its integrity.In the same way it is possible to defrost not only water, but also the cable channels that are under the ground.

Defrosting with hot water

Another answer to the question "how to unfreeze the plastic pipes on their own?" Will defrost with water heat.this method algorithm is as follows:

• If the ice plug formed in the drain.It is necessary to pour the hot water into the branch hole bath or sink.
• ice jams in other pipelines can also be defrosted by the same method.It needs to unscrew the protective cap in the pipeline and feeding it into a hot water via hoses.To enhance the effect, you can use a solid iron wire to mechanically act on the ice cap.
• can also produce plastic defrost open communications through direct effects on their skin with hot water.

Defrosting with electric cable

Requires two-core wire and an ordinary electrical plug.Wire is trimmed at the ends and the resulting exposed portions thereof are twisted together.On the other hand, this lead must be connected to the plug.This device, the bared ends of the forward is introduced into the pipeline until it stops.Then you need to insert the plug into the mains.Then, the formed ice plug is melted and formed melt water flows down either itself, or it is necessary to remove the hydraulic pump.It is worth noting that this method involves working with dangerous voltages.

Defrosting with hot air

Another aspect of cluster "How to defrost the plastic pipes on their own?" Is the thawing of plastic with hot air.Defrosting of the type produced by a conventional dryer assembly or by the action of an air flow of heat directly to the site of the alleged location of ice jams.Also, thawing can be done by installing an oil or vozduhonagnetayuschego heater near the pipeline.

Preventing formation of ice jams in the system of sluice

There are several ways to prevent freezing of water pipe:

• enveloping water supply systems insulated materials such as fiberglass, foam, basalt heaters.
• Creating an air layer between the pipes and the soil.In the national economy for this ordinary plastic bottles of various sizes are used more often.
• Location pipeline away from the concrete structures, since the proximity of this type of material can affect the intensity of the water freezing in the pipes the water distribution system.
• winding pipe heating cables.It is the most modern and effective way of preventing the freezing of water pipes made of plastic.It lies across the length of the tube and can be activated or deactivated as required.

Thus, in the article have been given satisfactory answers to the set of questions "how to unfreeze the plastic pipes on their own?".