Build Daily

Equipment

August 12, 2017 18:06

Washing machine does not take the laundry detergent or conditioner : causes, what to do

click fraud protection
Washing machine does not take the laundry detergent or conditioner
  • As the process should take place?
  • Should the powder is completely washed away?

Pawn clean and fresh linen - it is not only a powerful washing machine, but also high-quality detergent.Good washing powder enables us to keep things in perfect condition and, moreover, does not damage the internal device of the washing machine.

Powder or air conditioner are in the washing machine after washing - what to do

Sometimes housewives faced with such a problem: after washing out of the drum are removed wet, wrung out, but it does not extend the laundry with the remaining spots and malodorous.The reason for this is found quickly: it is enough just to open the washing powder feeder and you will see that the detergent remain intact.

about what to do if there was similar trouble with your washing machine, read in today's paper.

What should be the process?

to load washing powder and conditioner is a special container, which consists of several compartments, each of which is activated at a certain stage - for soaking, washing or rinsing.Each of the compartments is brought hose filler valve through which the water enters and "picks up" means.Further, the powder enters through the hose into the tank.

The exhaust valve and the water supply hose into a container of the washing machine for powder and air conditioning

Features of this system depends on the model of the washing machine.Older devices are equipped with only one a filling valve, which in turn directs the flow of water into each of the compartments.Modern units operating under electronic control module, equipped with several such valves, each of which supplies water in your drawer.

Openings for supply water to each of the compartments of the container of the washing machine

The most common is that detergents remain in the feeder, to blame a failed drain valve.Read more about the different types of damage, see below.

If the powder remains in the container washing machines - the solution

Should the powder is completely washed away?

If you have correctly calculated the dosage (usually the recommendations specified in the operating instructions of the washing machine), then ideally the powder should disappear from the feeder to the end of the wash, except for a small number of tools that can hide in a corner of the container.

The dosage of the air conditioner for the washing machine

powder may remain in the document feeder if you are asleep it is much more than that required for the washing mode.Moreover, poorly washed out of the substandard feeder detergents which dissolve slowly in water.If you notice that the powder gets off in clumps and sticks to the walls of the container, most likely reason is that.

The correct amount of detergent per wash cycle in the washing machine

Thus, before analyzing the washing machine troubleshooting parts, make sure that it is not in the excess of the quantity or inappropriate as a means for washing.

causes of the problem and how to resolve

reason

What happened?

What should I do?

Reversed compartments feeder washing powder

detergent loaded in the container chamber, which is not involved with the selected wash program (for example, in the bay, which is used for pre-soaking)

Carefully readuser's guide description of the washing program;study design feeder washing powder

weak water pressure in the pipes

Water pressure may vary as a result of maintenance work or if the constipation water valve is not open until the end of

Check the pressure by opening the cold inlet valve;if the head is weak, make sure the water freely flows into the pipe, then contact the housing office

clogged water inlet filter

water inlet filter is clogged debris, the remnants of detergents or slices of lime

Disconnect from the machine inlethose, just behind it you will find a metal mesh - this is the filter;carefully remove it and clean with a brush under running water

fault filler valve

faulty filler valve that is responsible for the water supply to the washing powder dispenser

Check the water inlet valve with a multimeter;if it is defective, it must be replaced (more on this in the article "Washing machine collects water off»)

fault injector

nozzle through which water enters into the washing powder dispenser can clog iztoo hard or dirty water;In addition, the cable may be damaged, regulating nozzle

repairs and the cleaning of the nozzles are engaged in service centers;also you can call home master repairman

Shoe openings for supplying water to the container of the washing machine or conditioner if the powder does not go out of it
Cleaning the drain filter the washing machine if the powder or air conditioning do not go out of the container

Another problem hindering the normal output of fabric softener out of the container - is the blockage of the drain cover.That should be done in this case, see the following video.

instagram viewer