To deepen the well with their hands

If the country has dropped the quality of water, and the well is almost dried up, then you need to perform the deepening of wells with their own hands.

We all know that the construction - an important element of the suburban area.

However, even regular cleaning and care will not be able to maintain its performance characteristics.

Before deepening the well to do with their hands, exclude the following reasons: the construction of wells or wells larger neighborhood, drought, frost, or the natural vibrations of the soil.

Rate, broken well or it can be natural causes in one month.If the water source is still dry, it means that you can start to repair it.

preparatory stage

methods recess maybe different, but before any of them need to take the following actions.

first - is to evaluate the possibility of carrying out the works.

Well should be a working, not twisted, drinking water can be used in deep water well is composed of 10 or more rings, the rings are not displaced by more than 4 centimeters.

If it does not meet these parameters, it means that you will have to dig a new one.

Deepening the well at the cottage is best done at a time when the groundwater level is low.In October or November, it will be easier to clean, the water level is below.

Before you begin, you need to make a payment - how much water is coming every day, how much soil can keep the walls intact, lies at a depth of water, as well as carry out geological exploration.

Deepening plastic rings

The first thing to do is to dismantle the ground part of the well.

further held water pumping and cleaning facilities inside the debris, sludge and other things.

also need to make the strengthening of joints.

inner rings fastened with metal staples, at least two for each joint.

Particular attention is given to the upper ring.

Video:

Deepening rings of smaller diameter

This technology requires the tube of smaller diameter plastic than the size of the inner shaft of the ring, and at least one meter.Pipe of this diameter will easily be able to go inside to the end.

The pipe needs to be done at least 50 holes with a diameter of 20 millimeters.On the inner side positioned stainless, with fine mesh net.This will filter.

specifically for this work by the Boers, otherwise they are called Bailer, meter dig a hole and put the prepared plastic pipe.The top of the pipe should not cover the water.

to pump out the water from the bottom, use the pump.For this work fit the electric pump to work at a depth.

Then start moving the tube down the storm well at a distance equal to two - three rings of mine.

Next comes the cleaning: remove sand, dust, soil, water is pumped from the bottom.

bottom Once purified, lower ring of a smaller diameter concrete than those from which the well is built.

rings fastened with metal staples, pay special attention to the joints of old and new rings.

a recess of smaller diameter rings can be viewed below.

Video:

Deepening the well at the quicksand

This method is used when the water source is located in the complex area of ​​soil, the so-called plyvuchem.Groove must be made manually.

With buckets conducted mine cleaning from the ground.

plastic pipes with rigid ribs descend into simultaneously with the deepening process.

Instead, you can use the pipe connected hydroresistant sealing rings made of plastic with threaded ends.As soon as water starts to come fast enough, deepening stop.

opening between the mine walls and rings fall asleep with a mixture of sand and cement in a ratio of 1 to 5.

This work is quite time-consuming, cleaning from the ground is carried out manually.And since the soil is quicksand, so as not to get bogged down, it is necessary to work on a wooden raft or special swing.

Note, in this method, the inner tube will be located over the whole length, unlike the first, where the concrete ring of smaller diameter than the inner, are joined with each other.

Watch the video as in-depth on quicksand plastic rings.

Video:

final stage

Having made the country one of the facilities of the restructuring of these methods, it is necessary to carry out the final event.

with a mixture of cement and water glass sealed all the seams and potholes, cleaning is carried out from the debris at the bottom of the filter is placed 15 cm (river pebbles, it can be replaced by coarse gravel).

It will consolidate the soil and reduce water pollution.

Finally, do not forget to disinfect with chlorine or manganese.

Video: