Proper lighting of the garage

basic requirements

first case consider the main requirements for the garage lighting

As a rule, to repairvehicle provided with an inspection pit in which due to poor heating and ventilation is formed dampness.In connection with this problem it is necessary to take care that the lamps in it are protected from moisture.The most appropriate option would be sealed, low-voltage products with a degree of protection not less than IP 45.

second requirement concerns the installation of switches in the garage.Again, the main point is that within the viewing hole breakers should not be.It is best to make these products on the main panel or the jamb near the front door.

Since most of the time you will have to "tinker" with the repair of the machine, the lighting should be qualitative.Bulbs should be installed in such a way that no object cast a shadow over the work area.

took seriously the settlement work.You should not only choose the right power light bulbs, but also a place of their installation.The classic way to install - "a light in the middle ceiling" is strictly prohibited.Proper lighting in the garage should consist of several functional areas, which will be discussed later.

Another important requirement - the light does not dazzle the eye.That is why the light sources shall be equipped with special reflectors and shades.

Options backlight

Another important factor - the correct placement of fixtures.There are several popular options garage lighting, which can be used for high-quality lighting throughout the room, but the most effective is considered to be multi-level.

In this case, the lamps are placed in four basic levels of the room: the top (ceiling), medium (1.8 meters from the floor), low (0, 75 meters from the floor) and minimum (0.4 meters from the floor).

With regard to the ceiling, then there it is recommended to install the product so that the light fell vertically, without creating shadows.This level is used for the general illumination of the garage.

Mid responsible for lighting the working area - on the bench.Here, as we have said, it is best to use a directional light lamps.

low level is useful for repair of the machine.When there is a need to repair the wing or door, the lamp at low altitude will enable qualitative illuminate the entire work surface.

lanterns installed at a height of 40 cm above the floor, make it possible to travel safely, asvery often on the floor may lie spare parts and tools through which you can stumble.

An alternative lighting in the garage is to use only three levels: the ceiling, a work area and spot lights portable lamp.This option is simpler and in practice is more common.

review the effectiveness of the system of lighting, you can also view the video:

I would also like to note that lighting option affects the number of simultaneous fixtures in one group.For example, you can place on the 3 items on each wall, and manage them using dvuhklavishnogo switch.In this case, a repair of the vehicle light can include only so much of the room where the repairs made.At the same time the opposite side of the room to be shaded, which saves energy.

This could add another option - use the switch-through.In this case, the lighting in the garage can be controlled from several points (for example, from different angles).

Useful tips

And finally I would like to give to you the tips on connecting the lighting in the garage:

1. If you decide to install street lights in front of the front door, then add to itMotion Sensor.In this case, the lamp will not work overnight, and engage only when you come to it.The result - energy savings.The alternative motion sensor can be a light barrier that reacts to street illumination (includes light after dark).
2. If the room is heated - Use fluorescent bulbs - if not, stop your choice on the LEDs.This is due to the fact that fluorescent lights do not work at low (and even more below zero) temperatures.For cold garage lighting is better to use light-emitting diodes.
3. sure to take care of the entire grounding wiring, otherwise injuries or accidents you can not avoid.
4. Prefer quality goods, not the cheap Chinese fakes.Save on the purchase of fakes, you jeopardizes their own health.
5. sure to protect the electrical circuit breaker and RCD.These devices protect the network from overload, current leakage and short circuit.
6. Make autonomous lighting in the garage, connecting the LEDs on the battery for 12 volt.Should you be without electricity and need urgent repairs, with charged battery, the light can burn up to 10 hours (depending on the wattage of light bulbs).It is also possible to back, and alternative sources of energy in the form of a generator or solar panels on the roof.We can also add lamps powered by batteries.

That's all that I wanted to tell you about the options literate garage lighting.We hope that the information is understandable for you, and most importantly - useful.If you have any questions, our experts will answer them in a "question and answer" category!

Also read:

• How to make ground in the garage with his hands
• How to make light on the balcony
• Which is better: electric convector heater or