Roll rubber flooring for garages

Nowadays cute rubber flooring has replaced an uncomfortable concrete floor in the garage.

It is not only pleasant to the eyes, but also protects the floor from street dirt, excessive moisture, etc.

Benefits rubber flooring

durable, resistant to moisture, abrasion, gasoline, motor oil and spikes rubber rolled flooring has spread as a floor covering for garages.

With increased density, it is not afraid of high loads, quickly and easily fits conveniently attached.

flooring technology coil coating:

1. Prepare the base.To this end, the floor is cleaned of dirt and dust is removed from it all superfluous and primed with a mixture of turpentine with polyurethane glue.In one square meter requires 300 grams of the mixture.The ingredients are mixed in equal parts;
2. After the primer has dried, on a flat floor surface material is rolled.On the floor, leaving no mounds, as under the weight of its own weight coating instantly straightened.It should lie down for several days, and only then it can be glued;
3. Fix polyurethane glue, applying it evenly on the surface of the material.Adhesive may be applied only in areas of the joint.

Ready floor perfectly maintained.It protects the car from corrosion, which causes the appearance of dampness.

Rubber flooring for the garage are available in rolls of a width of 120 cm and in the form of tiles.They have different thickness from 0.4 cm to 4 cm.

varying thickness is from 4 mm to 40 mm.All are available in a wide range of colors and are made from environmentally friendly components.

Video:

have rubber floor covering has many advantages:

• high durability and resistance to aggressive media.They are not afraid of atmospheric temperature fluctuations, the impact of acid and alkali, UV;
• permeability.Not afraid of water, they can be washed right out of the hose;
• Sound absorption;
• Anti-vibration properties;
• -slip properties that provides enhanced comfort while walking;
• Sustainability.

Floor coverings made of rubber crumbs are the product of recycling tires.

They consist of rubber crumb, polyurethane glue and mineral pigments.

As they are made?

Floor coverings made of rubber are made from rubber granules obtained from recycled tires from cars.

Worn tires are mechanically pulverized.

done this in several stages, with each successive stage of the diameter of the pulverized particles.

The result is a raw material for the production of floor coverings.

The technology developed in the United States.

to dispose, unusable tires, was invented technology of special granules.Of these, we began to make the flooring rubber-based.

Such production is quite simple.Little mixed on special equipment with a polyurethane binder.

Video:

To give the final form of the coating, to the mixture was added for coloring paste.Thereafter, the mixture is compressed.

finished rubber flooring gives a very aesthetic, it is possible to make a variety of colors and shapes, with a very smooth surface without any seams.

Manufacture of rubber flooring made of car tires, which are made from the most durable rubber.

It is resistant to acids and alkalis, elastic, strong in bending and stretching, long time not used up.

Since during operation of tires should experience huge load, only high-quality expensive components used for their manufacture.

Although eventually tire wear, the quality of their material remains on top.

His performance properties allow for mechanical harvesting.

You can also use a rubber modular flooring floor of the garage, which has the same performance characteristics.

modular tiles are laid without the use of adhesives, as it comes with a special hardware.

Where to buy and what price?

This high-quality material will remain in the absence of a more than a decade.

It has affordable price and is a great alternative to the concrete floor.

According rubber convenient to move, because it has a low level of sliding and falling on it, hard bump, because the floor is very soft.

Buy rubber floor covering for your garage and make it comfortable and easy, thanks to the super modern coating can be quite inexpensive.

better pay attention to gray or black color of the material to less than was visible dirt.

Price rubber outdoor coil coating having a thickness of approximately 0, 5 cm per square meter will be about 400 rubles.

This thickness is sufficient if the garage is passenger car.

Thicker materials required for the garage, where there are more heavy machinery, and in these places quite intensive exploitation.

maximum thickness of roll coating is 0.6 mm.

If you decide to buy a thicker, it will take a modular tile, but the price of rubber flooring modular coating having a thickness of more than 1 cm higher.

Video:

thicker rubber, the higher the cost.

only drawback roll coatings it is that if you do a little damage the floor, you have to change the whole band.